LITSCO's OmniWall CL panel is heavy duty clip mounted panel to offer a cost effective alternate to plate & ACM rainscreen systems. The pre-installed clips create fast installation to substrate.
Vertical or horizontal panel orientation allows this panel to fit to your design requirements. Kynar painted material can provide up to 30 year finish warranty.
Heavier gauge materials result in a stronger panel. Standard panels sizes in both small and large modules.
Can be rear insulated.
ASTM E330, E331 tested for structural integrity and ASTM E283 tested for water infiltration resistance.
All flashing and trim will be fabricated by LITSCO or a qualified fabricator. Flashing shall be .032" -.040" aluminum or 24ga steel.
Streamline Flush TG panels are intended to be installed directly onto 18GA (1/2") or 20GA (7/8") deep galvanized steel subgirts. Maximum subgirt spacing is 30".
#12 hex head, self-drilling stainless steel fastener with neoprene washer.
Set panel direct to subgirt, set joint to 5/8" wide, set backer rod and caulk joint with high performance Pecora silicone sealant
• Aluminum, .063" / .080", Finish per specification
See the Sheet Metal page for available material colors & finishes
Building Insulation Assembly
LITSCO's Streamline metal wall panels can fit a variety of applications, but does your wall assembly meet NFPA285 ratings? Use this guide to help choose what product assembly is right for you:
Visit the OmniWall CL Portfolio page for additional photographs